3D-Printed Dimple Dies

[ADennis11]

These are awesome!

[Lost_ham]

Found this forum from your Youtube short as well searching 3d printed dimple dies. Have you used pla? how well does it hold up?

[ADennis11]

Found this forum from your Youtube short as well searching 3d printed dimple dies. Have you used pla? how well does it hold up?

I used pla at 100% infill and it holds up just fine. I’m only bending 18ga with it though. Probably don’t even need to do 100% fill, I just did for the heck of it. I’ve probably only used mine for less than 10 dimples but no appreciable wear is showing.

[oldmetalbeard]

Thanks you for posting these dimple dies!

[nunums]

Thankyou for posting this man

[Sculptor]

I can't wait to try this out
Thanks for posting

[Jja081196]

thanks!

[LukasM]

This is a really useful print for us car guys, dimple dies are normally expensive!

Thanks for sharing.

Cheers from Austria,
Lukas

[kpporsche]

These look awesome Tom, can't wait to try them

[Knurd71]

Getting ready to go down this rabbit hole! These are perfect! Great Job!