Carpokes Porsche Forum

Looks great. I see spares... No one will yell at you or shake you down for money if you want to sell them here on Carpokes. We leave that to the other sites.

Yup, good work... That reminds me that I need a cover for the 16V pulley cover on my engine to replace the stock distributor...

That looks great and is a nice way to provide a signal. Two questions:

- What car is that sensor for, originally?
- What is the termination on the sensor? Going this route implies an aftermarket ECU, so you can use whatever connector you want, I'm just curious.

Cheers

Is it 3D printed?

Images come up as broken link symbols for me.

I can't see the photos in your thread, but judging from the comments this may be something I am currently looking for. Would you mind sending me more information?

Jlturpin wrote: Fri Jun 07, 2024 1:37 pm I can't see the photos in your thread, but judging from the comments this may be something I am currently looking for. Would you mind sending me more information?

The photos are no longer there - not sure the reason.

No matter, I'll alert @AudiSport per your need for more info.

Welcome to Carpokes!

blueline wrote: Fri Jun 07, 2024 2:25 pm

Jlturpin wrote: Fri Jun 07, 2024 1:37 pm I can't see the photos in your thread, but judging from the comments this may be something I am currently looking for. Would you mind sending me more information?

The photos are no longer there - not sure the reason.

No matter, I'll alert @AudiSport per your need for more info.

Welcome to Carpokes!

Thank you.

Hot linked photos expired from their source