Carpokes Porsche Forum

Not sure what this part is called but the plastics cracked and very ugly. Currently gutted the interior and would hate to leave one ugly piece on the interior.

Doubt if it's available separately. Maybe put the word out to one of the 3D print gurus.
I kinda have the same issue only I'm looking for the rubber bellow cover for the rear seat back latch pins. NLA

I was afraid of that; I'll see if I can't get them off as safe as possible and try and model them at some point for printing.

You might also check out some of the Used Porsche Auto Dismantlers ( yep, junkyards, ha ) as there are quite a few and you may have luck with your needed part. Some are highly rated, like Tom's Foreign Auto Parts , but this is just another suggestion that might prove worthwhile.