Carpokes Porsche Forum

Here is an STL for the white clip that holds the oxygen sensor to the back of the intake on the 944.

Factory part number is 999.651.224.40

This is printed in ABS with support. Printing it standing upright will increase the strength of the tangs, but either way the tangs are strong enough and stronger than most old/brittle clips. This is virtually identical to the original (what's left of mine shown for comparison), including the tab on the back that clips into the metal bracket on the back of the intake.

Thank you!

Thank you!

Technica RaceWire wrote: Thu Sep 14, 2023 3:50 pm Thank you!

Nice to see you here on Carpokes. I've been watching your progress on facebook. Welcome. I'm duty-bound to remind everyone that all STL models are for non-commercial use per the site license, but if you want to use one in your business, please reach out to me at [email protected]. Not looking for money for something like this, but would love it if you returned the favor with a shout out or two for Carpokes on your social media feeds.
Support the cause and all....

Great file !

Thank you!

Wonderful!