Page 3 of 3
Re: Mid-sleeves
Posted: Fri Nov 10, 2023 3:16 pm
by michaelmount123
Yes, Gruhsy, your sleeves are Darton flanged sleeves.
The "re-torque" I described is done cold during engine assembly, not after running the engine. I've found that re-torquing after running the engine is not necessary if my method is used.
Re: Mid-sleeves
Posted: Fri Sep 26, 2025 1:55 pm
by Globalmike
Just bring this post back. I am looking for a rebuild for my 3.0L 16V. I cant find michael mount contact.
Anyone else good?
Re: Mid-sleeves
Posted: Fri Sep 26, 2025 3:28 pm
by Fejjj951
Globalmike wrote: Fri Sep 26, 2025 1:55 pm
Just bring this post back. I am looking for a rebuild for my 3.0L 16V. I cant find michael mount contact.
Anyone else good?
Why don’t you send Michael a PM?
Re: Mid-sleeves
Posted: Sat Sep 27, 2025 2:25 pm
by Globalmike
I did, just wanted to see if there was a way to have a quick conversation about a rebuild.
Is there anyone else that does good work on these engines?
Re: Mid-sleeves
Posted: Sat Sep 27, 2025 5:26 pm
by 944m3
Globalmike wrote: Sat Sep 27, 2025 2:25 pm
I did, just wanted to see if there was a way to have a quick conversation about a rebuild.
Is there anyone else that does good work on these engines?
Chris White