Page 3 of 4
Re: 944 Flywheel Lock
Posted: Mon Jun 10, 2024 12:58 pm
by Glowstick
This will help a lot thank you, Much nicer then spending 80 dollars on one.
Re: 944 Flywheel Lock
Posted: Thu Jun 20, 2024 5:58 pm
by dillondopp
i wonder if the 3d printed flywheel lock will hold up under preasure though
Re: 944 Flywheel Lock
Posted: Thu Jun 20, 2024 6:17 pm
by blueline
dillondopp wrote: Thu Jun 20, 2024 5:58 pm
i wonder if the 3d printed flywheel lock will hold up under preasure though
A few of the comments further back in this thread might address your question somewhat.
https://www.carpokes.com/viewtopic.php?t=1687#p17645
https://www.carpokes.com/viewtopic.php?t=1687#p21657
https://www.carpokes.com/viewtopic.php?t=1687#p21944
Re: 944 Flywheel Lock
Posted: Sun Aug 11, 2024 9:35 pm
by cskvoretz
Excited to try this out during a belt change! Will help save some money
Re: 944 Flywheel Lock
Posted: Thu Oct 17, 2024 10:36 am
by Mjad23
I will give it a try aswell.
Re: 944 Flywheel Lock
Posted: Thu Oct 17, 2024 10:38 am
by Tom
Mjad23 wrote: Thu Oct 17, 2024 10:36 am
I will give it a try aswell.
Please know this was something of a design exercise at the request of another member. Printed in plastic, it will prevent the motor from getting inadvertently moved off TDC, but it WILL NOT be strong enough to loosen or tighten the crank pully bolt.
Re: 944 Flywheel Lock
Posted: Sun Nov 17, 2024 2:31 pm
by sallupo
Thanks for uploading the file man!
Re: 944 Flywheel Lock
Posted: Wed Dec 18, 2024 12:25 am
by baul
great stuff thanks!
Re: 944 Flywheel Lock
Posted: Sun Dec 22, 2024 3:54 pm
by KAL72
I'll give 3d printed tool a try!
Re: 944 Flywheel Lock
Posted: Thu Dec 26, 2024 6:41 pm
by Porsche944utah
Can't wait to try it