Email sent and will do on the recommendations!Tom wrote: Wed Mar 23, 2022 2:42 pmYou bet. Someone else asked for one recently, so I've been meaning to get going on making up a batch. In the past, I was charging $125 for them, but have offered them to carpokes members for $100. If you want me to make one for you, it'll take a week or two. Feel free to email me at [email protected] to make arrangements.[email protected] wrote: Wed Mar 23, 2022 2:06 pm Any of these left I can purchase? My speedo shows approx 5 MPH higher than what my GPS shows.. UGH
THANKS!
Tom wrote: Sun Mar 20, 2022 12:22 pm I had the PCB's professionally assembled, so was charging for these. I think the rack rate was $125 when I was last pushing them, so how about $100 shipped as the Carpokes valued-member discount?Email me at [email protected] if you want me to make you one. Not entirely sure where I stand on harness supplies, so might take me a week or two to pull one together.
viewtopic.php?f=19&t=267
SpeedoBooster
-
[email protected]
- Posts: 31
- Joined: Sun Jan 16, 2022 2:01 pm
- Has thanked: 6 times
- Been thanked: 3 times
-
Tom
- Site Admin
- Posts: 8932
- Joined: Fri Jun 25, 2021 2:04 pm
- Location: Silicon Valley, CA
- Has thanked: 932 times
- Been thanked: 3994 times
- Contact:
Yes, I had a batch of the PCB's professionally assembled at a local electronics place several years ago, and still have a dozen or so left. Takes me a while to program them, get them in the case, make the harness, etc., but I can usually get that done in a week or so depending on my schedule. Shoot me an email at [email protected] if you want one.Damo wrote: Sat Mar 22, 2025 2:00 pm I definitely need one of these. It’s been a few years since the last post so are you still making them @Tom?
