Carpokes Porsche Forum

These are awesome!

Found this forum from your Youtube short as well searching 3d printed dimple dies. Have you used pla? how well does it hold up?

Lost_ham wrote: Sun Oct 29, 2023 2:59 pm Found this forum from your Youtube short as well searching 3d printed dimple dies. Have you used pla? how well does it hold up?

I used pla at 100% infill and it holds up just fine. I’m only bending 18ga with it though. Probably don’t even need to do 100% fill, I just did for the heck of it. I’ve probably only used mine for less than 10 dimples but no appreciable wear is showing.

Thanks you for posting these dimple dies!

Thankyou for posting this man

I can't wait to try this out
Thanks for posting

thanks!

This is a really useful print for us car guys, dimple dies are normally expensive!

Thanks for sharing.

Cheers from Austria,
Lukas

These look awesome Tom, can't wait to try them

Getting ready to go down this rabbit hole! These are perfect! Great Job!