944 Flywheel Lock

[Glowstick]

This will help a lot thank you, Much nicer then spending 80 dollars on one.

[dillondopp]

i wonder if the 3d printed flywheel lock will hold up under preasure though

[blueline]

i wonder if the 3d printed flywheel lock will hold up under preasure though

A few of the comments further back in this thread might address your question somewhat.

https://www.carpokes.com/viewtopic.php?t=1687#p17645

https://www.carpokes.com/viewtopic.php?t=1687#p21657

https://www.carpokes.com/viewtopic.php?t=1687#p21944

[cskvoretz]

Excited to try this out during a belt change! Will help save some money

[Mjad23]

I will give it a try aswell.

[Tom]

I will give it a try aswell.

Please know this was something of a design exercise at the request of another member. Printed in plastic, it will prevent the motor from getting inadvertently moved off TDC, but it WILL NOT be strong enough to loosen or tighten the crank pully bolt.

[sallupo]

Thanks for uploading the file man!

[baul]

great stuff thanks!

[KAL72]

I'll give 3d printed tool a try!

[Porsche944utah]

Can't wait to try it