HVAC control unit diagnostics

Product Instructions, Repair Procedures, and Other Technical Downloads
User avatar
Tom
Site Admin
Posts: 5244
Joined: Fri Jun 25, 2021 2:04 pm
Location: Silicon Valley, CA
Has thanked: 488 times
Been thanked: 2309 times
Contact:
Here are diagnostic charts in a downloadable 5-page PDF format to help test the motors, solenoids, and sensors in the main HVAC flapper (heater core) box under the dash. Without testing these parts, it can be hard to know if the climate control unit itself is bad (common) or if one of the motors, sensors, or solenoids are bad (also common).


hvac diagpics pic carpokes.jpg


944 HVAC diagnostic test chart carpokes.pdf
You need at least one post on Carpokes to see and download files.


#1

User avatar
Tom
Site Admin
Posts: 5244
Joined: Fri Jun 25, 2021 2:04 pm
Location: Silicon Valley, CA
Has thanked: 488 times
Been thanked: 2309 times
Contact:


#2

RJB 968
Posts: 1
Joined: Wed Feb 08, 2023 3:05 pm
The video and check sheets are great - thanks!
My sensors all checked out and gave consistent readings. However the internal temp reads 50c....it looks like it has maxed out. The system wont produce any heat, which I assume is related to the reading on the internal temp gauge
What do I need to look for?

Thanks


#3

User avatar
Tom
Site Admin
Posts: 5244
Joined: Fri Jun 25, 2021 2:04 pm
Location: Silicon Valley, CA
Has thanked: 488 times
Been thanked: 2309 times
Contact:
RJB 968 wrote: Wed Feb 08, 2023 3:08 pm The video and check sheets are great - thanks!
My sensors all checked out and gave consistent readings. However the internal temp reads 50c....it looks like it has maxed out. The system wont produce any heat, which I assume is related to the reading on the internal temp gauge
What do I need to look for?

Thanks
Do you mean the sensor measured at A2 reads around 3600 ohms (~50c)? If so, I'd start by checking to make sure the sensor is soldered securely to the end of the wires... If it is, and if the sensor it self reads that far off, you can save a lot of money by just soldering a new sensor into the existing sensor assembly. See post #4 in this thread for a suitable replacement sensor and some pictures to show what I mean....

https://www.carpokes.com/viewtopic.php?t=1007


#4

Carl944
Posts: 1
Joined: Sun Nov 19, 2023 10:00 pm
Footwell solenoid failure here, so very useful


#5

User avatar
Belgian951
Posts: 120
Joined: Tue Oct 03, 2023 3:59 am
Has thanked: 41 times
Been thanked: 15 times
This is just in time. In my last drive, I noticed that the heating system is always putting out hot air. I put all sliders to the left, airco button off, fans on, temp dial on 18. Hot air always, at any fan speed.

I still have to do clarks' diagnostics tests but this will be useful.


1986 944 Turbo Garnet Rot Metallic

#6

User avatar
Tom
Site Admin
Posts: 5244
Joined: Fri Jun 25, 2021 2:04 pm
Location: Silicon Valley, CA
Has thanked: 488 times
Been thanked: 2309 times
Contact:
Belgian951 wrote: Mon Nov 20, 2023 5:22 am This is just in time. In my last drive, I noticed that the heating system is always putting out hot air. I put all sliders to the left, airco button off, fans on, temp dial on 18. Hot air always, at any fan speed.

I still have to do clarks' diagnostics tests but this will be useful.
When a 944 has hot air all the time, there's a 93.29% chance that the heater chip broke. :shifty:


#7

User avatar
Belgian951
Posts: 120
Joined: Tue Oct 03, 2023 3:59 am
Has thanked: 41 times
Been thanked: 15 times
Tom wrote: Mon Nov 20, 2023 7:23 am
Belgian951 wrote: Mon Nov 20, 2023 5:22 am This is just in time. In my last drive, I noticed that the heating system is always putting out hot air. I put all sliders to the left, airco button off, fans on, temp dial on 18. Hot air always, at any fan speed.

I still have to do clarks' diagnostics tests but this will be useful.
When a 944 has hot air all the time, there's a 93.29% chance that the heater chip broke. :shifty:
I hope this is the case for me, would be a cheap fix for once! :lol:


1986 944 Turbo Garnet Rot Metallic

#8

User avatar
Belgian951
Posts: 120
Joined: Tue Oct 03, 2023 3:59 am
Has thanked: 41 times
Been thanked: 15 times
Tom wrote: Mon Nov 20, 2023 7:23 am
Belgian951 wrote: Mon Nov 20, 2023 5:22 am This is just in time. In my last drive, I noticed that the heating system is always putting out hot air. I put all sliders to the left, airco button off, fans on, temp dial on 18. Hot air always, at any fan speed.

I still have to do clarks' diagnostics tests but this will be useful.
When a 944 has hot air all the time, there's a 93.29% chance that the heater chip broke. :shifty:
Sure looks like it.
WhatsApp Image 2023-11-25 at 15.32.39.jpeg
WhatsApp Image 2023-11-25 at 15.32.39 (1).jpeg
You need at least one post on Carpokes to see and download files.


1986 944 Turbo Garnet Rot Metallic

#9

Post Reply